Improved Guide for Carrera GO! slotcars 1/43

thingiverse

This is a guide for Carrera GO slot cars.It requires a 10mm M2 screw For Martin see:https://www.thingiverse.com/thing:6602056Very simple and clean adaptation, just remove the pin and install it with an M2 screw (10mm).Adjust the screw all the way but without locking the guide.If you want a guide that rotates 360º, you don't need anything else and it's a good improvement over the original pin.If you want a guide with a rotation limit, you must place a small wire (diameter of +/-0.8mm) behind the screw sticking out +/-1,5mmVideo with instructions:https://youtu.be/lZndDl9fL_o?si=WBp5imAmuvcvKiYzUPDATE:I discovered that at least for one of my cars (Skoda rally2) the guide was too long, so I designed a shorter version with 5.5mm.The standard one that works in all other cars tested so far with 6.5mm has also been redesigned to have a smaller base. This is V3 of my design.