Improved Dome for Flashforge Creator Pro

thingiverse

(Note: The link to this dome has been removed from thingiverse because I found an open version which doesn't use a support, here is the URL http://www.thingiverse.com/thing:2325371 ) (note: More information about the filament guide tube holder I use with this dome can be found here http://www.thingiverse.com/thing:1167693 ) Update (Jan 2017): FlashForge has been shipping its 2016 models with a new single-piece dome made of acrylic instead of the flat sheet version which is attached by screws in the older versions. Although the new dome still uses the same T-shape cut at the back for the filament tubes, this setup seems inferior to the one on the MakerBot Replicator 2X because the tube rises up without a cut. Update (Feb 2016): Humanisticnick reported that this dome works perfectly with FlashForge Creator Wooden. He just had to trim his filament guide tubes down slightly for it to work properly. This improved dome has been designed specifically for FlashForge Creator Pro and provides several upgrades compared to the stock version: Better filament path: The new design moves freely. Improved heat enclosure: Since the opening is located at the bottom, it prevents any drafts from getting in. Upgraded construction: Made as one single piece unlike the stock dome. More visually appealing. The original dome that came with MakerBot Replicator 2X Acrylic Dome Cover is also mentioned but unfortunately can not be fitted inside Flashforge case. For holding purposes, two strong magnets from Amazon were placed on it (CMS Magnetics, neodymium). But, to prevent high-impact effect, first attach them at a side angle before rotating the surfaces until they're fully contacting. Another modification made involves adjusting the tube holder in order increase center feed point with better design angles. This adjustment was needed because stock feeder could not accommodate the desired distance requirements when properly spooled. A link pointing towards custom filament feeder may be viewed from personal website which serves users and can assist anyone struggling with setting their machines as they attempt making successful prototypes on own using these upgraded improvements!