Improved ASG CZ-P09 Magazine Baseplate with Logo

thingiverse

This is an improved version of rene1960's magazine baseplate with added a CZ Logo on the bottom.Sharp corners have been rounded off and tolerances were slightly tightened, especially at the front, to insure a firmer fit without wobble and safer locking of the mag.The overhang at the rear has also been trimmed down. The hole beneath the gas fill port has also been removed for better looks and to ensure dirt doesn't get into it.Recommended print settings for my Ender 3 using eSun PLA+:-0.12mm Layer hight-220C/67C Temps (so it sticks to the bed better, ensuring the logo comes out well and impact stregth is good. Gluestick and slightly higher initial layer flow also helps.)