Imperial Dominion Crusader rearming platform assessories

thingiverse

Never run out of ammo in the field again with this Mechanicus unauthorized rearming system developed by Imperial engineering division XXI. ***Update: New platforms are completed and will be maintained as separate kits. Please see the remix section "Imperial Walk Ways" and "Imperial Support Beams". Note that this project is no longer a work-in-progress - All accessory parts have been test printed and should not change. However, both structural components are still under development. The only part that may need modification is the main forge unit. It prints fine but needs a spacer on top to meet up with the walkways. To print a complete Crusader rearming platform (as shown), you will need to print: Main Structure (see Remixs) 2x Imperial Walkway Curved A & B Your choice of any 4 Imperial Support Beams 1x Connector piece - not yet published (will be in Imperial Walkways) On Top 1x Rail 3 post A & B - Tested OK- part B with clips is new 1x Rail shield A & B - New version tested OK. part B with clips is new 1x rail with fan A & B- v2 changes made - both tested OK - part B with clips is new 1x fan pipe - Tested Ok (final - no changes expected) 1x energy loader pipe - Tested OK (final - no changes expected) 1x console - v2 changes made - Forge 1x Main forge - test printing 3/7/18 Too small! Gap between forge and walk way is way too large. Will be fixed soon 1x secondary pipe - Test print failed. Prints fine but falls apart. Also needs re-scaling and does not fit nicely on main forge piece. 1x pipe top end - Test printed really well. Need to check it fits with other pipes - checked and it fits loosely. Needs rescaling and further adjustments. 1x Forge hat - so your forge doesn't get sunburned Assembly Instructions: Walk way A & B should just fit nicely together without glue (don't glue until after painting!) Walk way B and supports should now slot together (testing still required). To join the two completed walk way pieces (remember you need 2x of each A & B) I've included a connector piece that should slot into the holes. Supports: Glue part A & B together, glue C & D together. Slot into walk holes in walk way B Rail with fan: Glue A & B together and then glue to pipe. Clip onto completed walk way Other rails - glue A & matching B together and clip onto walk way Main forge: Print all parts. All parts should slot into each other. Glue if needed As this is still under development, any feedback is greatly appreciated. Also note that this project was entirely created by hand using Tinkercad and is inspired by similar models. It is intended to add to, enhance, and be compatible with said inspired models, and is by no means a replacement.