Imogen Heap 2010 tour tree

prusaprinters

<p>This ornament is a reproduction of the tree used on the stage set for Imogen Heap's 2010 Ellipse tour. In the photo which shows two models, the one on the left was produced by Shapeways in laser-sintered nylon and cost about £15 in November 2010. The one on the right was printed in ABS on my eMaker Huxley for about 20 pence.</p> <h3>Instructions</h3> <p>Print with 1 perimeter and solid fill. The main tree outlines are meant to be 2mm thick, so you may prefer to use a layer height that will divide exactly. (Interestingly, if you stick with 0.3 mm layer height, skeinforge will round down to 6 layers = 1.8 mm, whilst Slic3r rounds up to 7 layers = 2.1 mm).</p> Category: Other