Immobilizer Remote Case for Autowatch 277RLi & 446RLi

thingiverse

I had an issue with my Autowatch 277RLi Immobilizer Remote PC Board that stopped working (issue was the SMD / LED light that came loose from the board causing it to stop working) I had to break the original remote casing because the screws were old and unable to remove. I printed this case for the Board after I repaired the LED. There is a lower part, an upper part and a button you need to print, some smoothing of edges may be required after the print to make everything fit nice and tight. The lower case has a gap where the upper case needs to slip in then press down and clip it all together. See photos of old remote type