Immersion RC 5.8 GHz 600 mW VTX Case

thingiverse

I designed a protective casing for the IRC 600mW 5.8GHz VTX that's worth checking out. When you secure your antenna with a screw, it'll push against the case tightly, effectively 'sandwiching' the case between the square part of the SMA jack and the antenna. I've used it without any crashes so far, but its intended purpose is to prevent the SMA jack from coming loose on the board. Below are some print settings for a well-made version: Print it in both ABS and PLA (ABS has a tighter fit around the SMA jack) Set your infill at 35% Opt for two shells Use a layer height of 0.2 mm