iMac 2.5" HD Holder

thingiverse

This object was created using Tinkercad software. I designed this holder specifically to conceal a 2.5-inch hard drive on the rear of my iMac. You can print it without any brim or supports. To minimize printing time, I optimized the design to take approximately 30 seconds to complete on a Vertex 8400 printer. Two 4-5 mm wide rings, cut from an old bicycle tire, were used to secure the hard drive in place within the holder. So far, this clip has fit successfully on both a 27-inch iMac (2009 model) and a 21-inch Retina iMac with aluminum casing.