Illuminated Angel

thingiverse

Angel can be illuminated by RGB LED. A Lipo battery and charge controller are integrated into the base. Of course, the Led can also be supplied directly with the USB voltage of 5V. Then a resistor of 33 Ohm instead of 10 Ohm would have to be used. The figure is printed without infill. My slicer settings for the figure (Cura): Layer height: 0.1 Wall thickness: 1.2 (3 x 0.4 wall lines) Top/Bottom Thickness: 0.8 Filling: 0% Combing mode: off Supporting required - best use Cura tree support. The white filament should be translucent. Suitable are e.g.: Geeetec or janbex. Printing without filling is only possible without a hole at the bottom. Therefore, the hole at the bottom has to be drilled after printing. Additional parts required: Switch, e.g.: https://www.ebay.com/itm/332771007314 2 RGB-LED slow, e.g.: https://www.ebay.com/itm/282083177174 Lipo charging module, e.g.: https://www.ebay.com/itm/263782499558 Lipo, e.g.: https://www.ebay.com/itm/183257989282 (also 100mAh or smaller possible) MICRO USB adapter, e.g.: https://www.ebay.com/itm/153515136089 10 Ohm resistor (not a 22 Ohm resistor as in the picture) The base-bottom should be printed in white so that the LEDs of the charge controller are visible when charging. https://www.youtube.com/watch?v=PvKLxZqKqRQ