Ikea UTÅKER Stackable Bed Raiser

thingiverse

I make no claim or warranty about safety or stability of these under any load, and you use them at your own risk. I purchased this bed from IKEA: http://www.ikea.com/us/en/catalog/products/30360487/ As it turned out, the mattresses they displayed with it were approximately an inch too tall for the beds to stack properly, so I created these risers to fit between the beds and accommodate the added mattress heights. They have a side with a hole that fits into the top bed's peg, and a peg on the opposite side that fits into the bottom bed's hole for stability. I also gave them the same curvature as the bed legs to blend in aesthetically. These risers give a 1.5" rise so you can comfortably accommodate a 6" mattress instead of a 5" mattress when stacked. I printed them with 65% infill because I was concerned about the sturdiness and support in case someone accidentally sat or jumped onto the stacked beds while the risers were in place. Feel free to send me a tip if you like what I've done! Click Here: https://www.thingiverse.com/Frank_The_Tank/about