Ikea UTÅKER Stackable Bed Raiser

prusaprinters

<p>NOTE: I make no claim or warranty about safety or stability of these under the bearing of any load. You do so at your own risk.</p> <p>I had Bought this bed from Ikea: <a href="http://www.ikea.com/us/en/catalog/products/30360487/">http://www.ikea.com/us/en/catalog/products/30360487/</a></p> <p>Turns out the mattresses they displayed with it were about an inch too tall for the beds to properly stack, so I made these risers to fit between the beds to accommodate the added mattress heights. They have a side with a hole for the top beds peg to fit into, and a peg on the opposite side to fit into the bottom bed's hole for stability. I also gave them the same curvature as the bed legs to blend in ascetically. They give a 1.5" rise so you can comfortably accommodate a 6" mattress instead of a 5" mattress when stacked.</p> <p>I printed them with 65% infill because I was paranoid about the sturdiness and support in case someone accidentally sat or jumped onto the stacked beds while I had the risers in there.</p> <p>Feel free to send me a tip if you like what I've done! <a href="/Frank_The_Tank/about">Click Here!</a></p> <h3>Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>Wanhao</p> <p class="detail-setting printer"><strong>Printer: </strong> <div><p>Wanhao Duplicator i3 V2</p></div> <p><strong>Rafts:</strong></p> <p>Doesn't Matter</p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>No</p></div> <p><strong>Resolution:</strong></p> <p>0.2mm</p> <p class="detail-setting infill"><strong>Infill: </strong> <div><p>65%</p></div> </p></p></p> Category: 3D Printing