IKEA Stuva enclosure Porthole pass-through (for Shelf) with swivel guide

thingiverse

I created a modified version of buddyO's swivel filament pass-through design for my Stuva enclosure, which sits between two shelves rather than at the top section. To accommodate this setup, I reduced the depth of my design from 30mm to 18.4mm, as it only needed to be that deep. I remixed the larger part that houses the swivel, leaving the original parts - the swivel itself, the cylinder it prints in, and the flat cover - unchanged. BuddyO's post provided the necessary dimensions for my modifications: * The diameter of the center hole to drill for the porthole is 38mm. * The diameter of the four smaller holes is 6.4mm. In preparing for drilling, I used a unique method: my wife's lipstick to mark the correct spots on the shelf. To seal any potential gaps and prevent heat loss from my enclosure, I applied silicone caulking around the top and bottom edges.