Ikea Stuva Enclosure: Filament funnel and runout sensor bracket

thingiverse

I use the IKEA Stuva enclosure for my printer and wanted to move the Filament spools on top of the box. So I drilled a 10mm hole into the middle and created a filament guide/funnel, which will be pushed from the top into the enclosure. The second part is a filament-runout sensor bracket. This part will be pushed over the funnel and locks both in place. You can add an M3 screw to tighten up everything, but is usually not necessary when printing with 0.20 layer height. The runout sensor on the photo is the usual 2 euro aliexpress sensors, which are available everywhere. Works out nicely :)