IKEA RÅSKOG Benchtop and Tool Holder

prusaprinters

<p>Adapters for adding a benchtop to the <a href="https://www.ikea.com/au/en/catalog/products/70376721/">IKEA RÅSKOG trolley</a>. Great for the workshop or anywhere you want a small mobile bench with storage.</p> <p>I had a spare piece of kitchen bench which I used for the top which was about 37mm thick but anything thick enough to take the screws should work fine. Also included is an optional tool holder for the edge of the bench. I used it to hide the unfinished edge on mine.</p> <p>Most materials should work but I used PETG in my case. The screws I used were also from IKEA but anything sensible should work. The challenging part is positioning the brackets correctly and getting the locations for them.</p> <p>I fixed the brackets to the top of my trolley as best I could with blocks under them to stop them falling. Then added small screws through the holes so that when I pushed the bench down onto them it marked the hole locations. Its critical that they are correct since the bench just slides onto the top of the trolley.</p> <h3>Print instructions</h3><p>Licence: Creative Commons - Attribution - Non-Commercial - Share Alike Category: Organization</p>