Ikea Pinning wall mout spacer

prusaprinters

<p>A spacing block to allow more secure wall mounting of the Ikea PINNING coat rack.&nbsp;</p><p>My recommendation is to print four of these at a higher infill rate than normal prints, I printed at 40%.&nbsp;</p><p>When fastening the Ikea PINNIG to the wall simply remove the included screws where the first and second coat rack fastens to the two center most poles. Drill and fasten wall anchors in the appropriate positions on your wall then just slip a block behind each empty screw hole.</p><p>I would advise to cut out a piece of felt with a sticky side as not to damage the wall when tightening the screws.</p>