IKEA Malm Headboard (41mm) CPAP hose holder

prusaprinters

My IKEA Malm headboard is thinner by almost 1cm than the original model. I had printed a block to shim it to fit for the 1st CPAP user but the grip diminished over time as the PLA crept under the stress. Eventually, I taped the holder in place so the holder still worked but I wasn't happy with how it looked up close.When we added a 2nd CPAP user, it was time for an overhaul. I reduced the depth of the bridge to be close to the thickness of the headboard plus a 3M Command strip. I added a sloped run-off from the hook opening to the rear leg to brace against stress creep. I filleted most of the edges to make the hook smooth to the touch.The holder should be printed on its side and requires a brim to get good bed adhesion due to the fillets.I installed the holder with a 3M Command Strip on the rear leg so that it's hidden when installed and it prevents the holder from sliding laterally on the headboard.