Ikea Lagra Replacement Mast Block

thingiverse

The block that holds the lamp onto its stand cracked into about four pieces at some point in time. I tried sticking it back together with glue, tightening it up with screws, heating it till it melted and covering it with tape but eventually I figured it would be better to simply design a new part since a repair wasn't feasible. Print Settings Printer Brand: Solidoodle Printer: Solidoodle 3 Rafts: Doesn't Matter Supports: Doesn't Matter Resolution: 0.2 Infill: 25% Notes: Print threaded hole UP. You might have to lightly sand the bottom hole where the lamp clicks in depending on your printer and your first layer settings. It's a tight fit, but it definitely isn't going anywhere! I didn't need supports, but make sure you have good air circulation with PLA or the overhangs will warp and get stuck. Supports could be an option if you have extreme warping. Post-Printing Before I added curves to the model to make it more appealing