Ikea Lack Wast Bin

thingiverse

I'm using an Ikea Lack table for my Ender 5 printer stand, and I found over time I was building up a lot of debris from purge lines, failed prints, etc. at the bottom of the printer frame, so I decided to design this waste bin that will attach to the side of the Ikea Lack table. I wanted it large enough to hold a substantial amount of plastic scraps and waste, and I wanted it to be easily removable for dumping. This is made with a friction fit, and should clip nicely on the side of the table. I did include 4mm holes on the top tabs so you could affix it with screws if you so choose, but its really not necessary, and would make emptying a bit less simple unless you choose to use a small liner bag.