IKEA Lack Table Stacker and Raiser (No Screws needed)

thingiverse

#Status + First test print is running, will update tomorrow. + First test print was successful, uploaded v2 to use less material. + Realized that at least two times v1 (vertically aligned) are required for stability, but it then works fine. The other two can be v2 to minimize material usage. #Target: + To stack 2 IKEA tables for an i3 plus enclosure, as they don't fit over each other with the i3 plus inside. + Requires no screws and holds itself together. + Approximately 2mm tolerance is acceptable due to IKEA's lack of precision. + Four of them should be printable at once on the i3 plus.