IKEA LACK Setup By Monberg75

thingiverse

I set up this setup for my Ender 3 printer because space was a major constraint for me.\r\n\r\nThe raisers are 10 cm in height and fit perfectly onto the legs of the table. On top of each raiser, there's a hole for a 5x5 mm cube magnet, and I used a roofing nail in the middle of each table leg to secure the upper table in place, just to make it more stable. It can be left out without any issues.\r\n\r\nYou'll need to print four raisers (Just let me know your height preference and I'll create them for you). Once printed, they will go into the collection.\r\n\r\nYou'll also need to print four upper corners for the top table.\r\n\r\nFor the top and bottom tables, I used super strong magnets that are 4x1mm in size. To accommodate these magnets, I created a hole that fits them perfectly, allowing you to superglue them into place on both the top and raiser.\r\n\r\nHere's where you can find the disc magnets:\r\nhttps://www.supermagnete.de/eng/disc-magnets-neodymium/disc-magnet-diameter-4mm-height-1mm-neodymium-n45-nickel-plated_S-04-01-N\r\n\r\nAnd here's where you can find the cube magnets:\r\nhttps://www.supermagnete.de/eng/cube-magnets-neodymium?length-or-diameter=5.00,12.00&lifting-force-kg=0.00,6.30\r\n\r\nFor the sides of the setup, I chose to use 4 mm Riatherm dual layer plastic board.\r\nHere's where you can find this board (The website is in Danish):\r\nhttps://www.jemogfix.dk/termoplade-riatherm-4-mm-1000-x-700-mm/4139/9040069/\r\n\r\nFor the filament holder, you'll need to glue a piece of wood beneath the top table so that you can screw the holder firmly into place.\r\n\r\nI've attached the STL file for the new roll holder and it's actually a reworked version of this popular design:\r\nhttps://www.thingiverse.com/thing:3114139\r\n\r\nThe bearing I used is available here:\r\nhttps://www.thingiverse.com/thing:2482146\r\n\r\nTo find the perfect bearing for your printer, you can use this tolerance test tool:\r\nhttps://www.thingiverse.com/thing:2318105