Ikea Lack Printer Enclosure - Magnetless Remix All-in-One

thingiverse

This is a remix as issues arose with attaching plexiglass holders to the original model, prompting a cleaner all-in-one look. Original project can be found at: https://www.thingiverse.com/thing:2226678 This model is specifically designed for 500x500 panels of 2.5mm plexiglass. There are five models included: Universal Lack Leg.stl is the classic leg with holders on each side. Front Left and Right Lack Legs.stl are remixed versions that remove the clip but leave the overhang, allowing combination with a mod that enables a plexiglass door. Update 12/30/2017: I added three more models. Front Left/Right Lack Legs with Clip Holders.stl are modified front legs that allow for a clip at the bottom (Bottom Front Clip). This is for using a Plexiglass door while still clipping it shut during operation. These have been made hollow to save on materials and were suggested by someone else in the main comment thread. The clip should be a tight fit, so scaling may be necessary if it doesn't slide properly. Please refer to the print settings section below for updated printing information for these parts. The Lack Top Bracket and Clips are included for completion but have not been remixed. Update 1/21/2018: Hollow versions of the original legs have been added to save on material. For the Cabinet: The handle for the Plexiglass comes from here: https://www.thingiverse.com/thing:2459045 The stackers used to put an additional Lack table underneath this setup come from here: https://www.thingiverse.com/thing:2476441 Remixed Plexiglass arm, base, and back pieces have been added specifically for this build. These originally came from here: https://www.thingiverse.com/thing:1831572