IKEA Lack Camera Mount

prusaprinters

I've used several mounts before (designed a few others) and my biggest challenge when attaching mounts to the IKEA Lack was when I needed to take my enclosure off and the camera was still attached while I wasn't paying attention.So, I designed this one to hold the camera wherever I wanted on the outside of any part of the table.It has a standard ¼" mount hole for any camera, but I use it for my Logitech c920.   If you don't have a bolt to attach your camera, I've included a model for one.  I also included a hole in the bottom in case you wanted to permanently mount the bracket onto the table.  It should work with the enclosure since it recesses a bit to give the enclosure some space.I don't know if anyone else wants this, but it's been very useful for me, so here it is.No supports needed.Note:  The side ratchet pieces are a bit fragile.  I don't move mine a lot, so it's not that important to me.  If it's a huge issue for others, I could probably come up with a different design for holding it in place.