Ikea Gulliver risers

thingiverse

A height adjustment/riser for Ikea Gulliver kid beds can be created using two units placed below the feet in the bed end to change its angle. Files are available upon request to fit more beds and provide room for higher lifts, but they have not been tested by me. Feedback is requested if you test them and something isn't working or they're too unstable. The screw can be screwed down into the base to achieve a 20mm lift at the lowest point. The base is 5mm thick below the threads, and the screw has 15mm from its flat surface where the bed feet rest to its bottom. Thread length varies in the file name so that a 40mm thread means a total height of 45mm with 10mm of threads intersecting, resulting in a 50mm lift at maximum and 20mm at minimum. The screw with a 70x30mm cutout provides space for an Ikea Gulliver leg, while the round version can be used on other types of legs. Safety is essential. Check that the unit is stable and doesn't pose any danger of the bed falling. I have only tested it for personal use, so you should do the same. The higher you go, the more unstable it will become by nature, so don't use it if it doesn't feel safe.