Ikea Dioder LED strip on Ultimaker

thingiverse

This IKEA Dioder LED strip mount utilizes a clamp for fitting onto Ultimaker's wooden components. Both long and short versions, suitable for left-right and front sides, can be used. Additionally, a tulle is provided for the power cable management. To install, print four short versions for the left-right sides and two long ones for the front. Due to the Ultimaker handle, rear side LED strip mounting is not possible. A 8 mm hole should be drilled at the left rear for cable routing. Feed the IKEA power cable from the top through the hole, behind the Y-stepper motor via the cable duct, and attach the small white connector to the bottom while leaving the large transparent connector at the top. Cover the power cable with the provided tulle and secure the hole. The standard IKEA power adapter is used in this setup, and the design is partially inspired by Johan van 't Hull's (ID 32373).