Ikea Desk Lamp

thingiverse

The design is specifically tailored for this cord set: https://www.ikea.com/us/en/catalog/products/40427562/ The thin walls of the design are only .5mm thick, necessitating a .25mm layer height during printing to ensure two passes equal .5mm and eliminate infill in those areas, allowing light to shine through unobstructed. White PLA was used for its pleasant glow when paired with a warm white LED bulb. Supports are required under where the socket connects to and inside the cord hole; however, it's possible to omit them from the cord hole if one has confidence in their printer's bridging capabilities. This design enables the cord to pass through the side hole intact, eliminating the need to disassemble and rewire the lamp. Though I accidentally purchased a switchless Ikea cord, thus preventing confirmation of whether the switch will fit through the hole.