iFlight XL8 v3 DJI FPV System Parts

thingiverse

The iFlight XL8 v3 frame provides ample space to accommodate the DJI FPV System camera and Air Unit with minimal adjustments required, aside from adding a few TPU components.\r\n\r\nTo integrate these components seamlessly, it's essential to mount the rotor arms under the bottom plate, ensuring sufficient clearance for the stack and Air Unit. This slight modification allows for a straightforward installation process, requiring only the addition of TPU and DJI parts.\r\n\r\nWhen integrating the GoPro Hero7 mount, two 15mm standoffs are needed in the middle section to enable secure screwing into place - a clever adaptation that deserves appreciation.\r\n\r\nThe build showcased was designed for a full DJI stack setup, thus omitting the RX antenna; however, an STL file has been included for a Crossfire Immortal-T mount that fits snugly under the bottom plate and attaches using standoff screws.