iFlight XL5 v4 DJI Camera Mount (For 5mm Frame Extension)

thingiverse

I retrofitted my drone built on an iFlight XL5 v4 frame so I could use a DJI digital FPV air unit/camera. This requires custom mounts and even with just the FC and Air unit stacked, I had to extend the frame height by 5mm. This model is meant to provide a way to mount the DJI FPV camera. The model uses the existing slots in the top/bottom plates to attach to the frame. It adds 2.5mm plates to the top and bottom to accommodate for the 5mm extension. I also changed the mounting hole pattern used in the original mounting plates. The original pattern can't even mount the DJI camera with both screw and has no way to control camera angle unless again you use 1 screw. I added a screw pattern to allow you to easily control camera angle from 0-90 degrees. Note that I included an STL of the model laying on it's back as this helped reduce supports necessary considerably and removes supports from the inside of the model. Haven't flown yet, but fit looks good to me so far! :)