iFlight MegaBee DJI Air Unit, Camera and Antenna Mounts

thingiverse

These components are designed to upgrade an iFlight MegaBee V2 cinewhoop for use with a DJI Air Unit. You'll need to drill several new holes in the top plate to accommodate the air unit using M3 nuts and bolts. The antennas fit inside the tubes, allowing them to be angled for optimal diversity. Secure the tubes and brackets with a 20mm M3 bolt and nut. The antenna mount and camera mount are designed to push onto the rear and front standoffs. When assembling the quad, take care not to allow the air unit to come into contact or short anything on the flight controller or ESC PCBs. There is enough space to fit a battery strap between the top plate and the air unit. You may need to trim the Air Unit mounts slightly if they obstruct the ducts. All of these components will print in TPU without any supports required. https://www.youtube.com/watch?v=86pqA0ADMlU