Idler clamp

thingiverse

Thank you very much schlotzz for the original design on this direct drive extruder! Mainly, I was able to break an idler because too great a pressure caused the pin to snap, so I then wanted a simple add-on without changing anything from the original design like this: anyone who already has this extruder can use this little clamp. You'll just need to use a bit longer screw - 20mm to 25mm for the swivel and a 16mm to close the idler and clamp together. Postscript/NOTE: I should have checked out that remix, because someone else had done something similar; but, in the end, this design came from deep within my imagination.