Ideal Standard Conceala 2 dual flush repair parts Updated!

thingiverse

This is a fix for repairing the back of two flush button pumps that had broken off from the faceplate, leaving the mechanism exposed behind. It's a long shot that someone might need this, but the work has already been done, so here it is. First, pull off the thin plastic pipe attached to the button assembly leading to the plumbing. Be careful not to lose the pipe in the wall. Next, insert the button assembly into the repair part and assemble as shown in the picture. I used superglue, which seems fine. To secure the repair, first assemble it, then apply a few small drops of glue around the joint. Reconnect the pipe to the back of the button assembly and refit it to the wall. The job is done. To 3D print this part, use a layer height of 0.2mm with 100% infill. Printing time for the smaller model will be approximately one hour and thirty minutes, while the larger model will take about two hours and five minutes. Note: For the larger model, it's essential to add support material to prevent the overhang from failing during printing.