ID Card Holder 2x ID Card 1x Token

thingiverse

Original designer: PopsActual Remixed for improved strength. In my experience with the source design, the ID card holder would break very easily at the top where the access/slide out holes were. I was also printing with PETG but probably not much of a factor as the layer orientation was the same (printed vertically per source design instructions). The remix: You'll notice there is no hole at the top to clip your lanyard to. This is because I designed it to utilize the small key ring that is part of your token. If anyone really prefers to attach their lanyard to a hole/slot at the top of the ID card holder just post in the comments and I'll add the STL.