ID Badge, RSA Key and 2nd card holder

thingiverse

This is a remix of devivero0186 original RSA key badge holder. Suggested settings: + Scale up by 2-3% + Less than 1.4mm first layer. It has a relatively small footprint for its height. + 1.5mm or less layer height. + Use a lighter or heat gun to loosen or tighten the RSA key slot. With 2% up-scaling, it's a very tight fit. I needed a badge holder that has an RSA key slot and could hold a second card. A slot was added in the middle to slide in a second card with two offset bars providing tension so it doesn't fall out. A window was added to the back so you can use a finger to slide the card out. I encountered a small issue of the card getting locked in place but a quick run through the slot with a nail file loosened it just enough to make the inner card slide out easily without falling out. I don't want to alter the source file because printer tolerances, filament shrinkage, or evil spirits could make it not work and 2 seconds with a nail file is fine for me. The lanyard attachment point was moved to a top-mounted tab and holes were made for a beaded chain.