ID Badge Holder

myminifactory

Purpose I needed a new badge holder for work, so I created a replica of a busted holder from a colleague. The dimensions should accommodate two cards snugly on one side and one card on the other. I suggest using the "horizontal" print orientation as noted in the "Print Settings" section. Changelog v1.0: Initial Release v1.2: Corrected some dimensional inaccuracies in the spacing of the card slot. v1.3: The 1.2 fit was successful, but could be too tight if using materials with any contraction during printing. Added another .25 mm tolerance for the internal length. v1.4: Structural support was added to the main body. I had been too aggressive in removing supports from a print and noticed a seam which needed some work (because, you see, I broke it). v1.5: The missing tension strips were readded on the back face of the model. v1.6: The spacing was corrected on one set of the tabs. Once I gain a better comfort level with Fusion 360, I'll add a model where all edges will be filleted and outer corners rounded out to soften out the pointy bits.