iCEBreaker Housing

thingiverse

This is a simple housing for the iCEBreaker FPGA-Board. It can hold the board and the PMOD-Module which comes connected to it (do not snap it off). The printing time (on Ultimaker S3) is less than an hour. What you will need to mount the device in place: - 6x M3 x 8mm bolt - 6x M3 x 5.7mm (or less) injection nuts and something hot to melt them into the plastic. - 4x washers (I added a model to 3D-print them). These prevent you from scratching the PCB My PCB actually already held in place without any screws, so maybe that works with yours as well. If you like this design, then you might want to be me a coup of coffee: https://www.paypal.com/donate?hosted_button_id=Q4Q78JBPUZBDJ