IceBox Can Holder

thingiverse

This 3D model was designed specifically for the firstBuild Makerbot Icebox Challenge. To get started, follow these instructions: The main goal of the 3D models is to hold eight- to ten-ounce cans securely inside a fridge or icebox. Unfortunately, there are some essential components that cannot be 3D printed and will be required for this design to function properly. Below are the additional parts needed: One metal spring with a diameter of exactly 0.2 inches should be inserted between the claws in two separate holes. Two pieces of high-quality, double-sided foam tape must also be attached to the model's surface. Finally, a net made from flexible material and measuring precisely three-point-five inches in diameter is necessary for securing the can within the claw's base compartment.