Ian Wright Spec Design

myminifactory

These are specs tailored specifically for Ian Wright. The entire design was created and carefully selected based on his 3D face scan. There are two distinct variations in the design, one with a frame and temple featuring a small gap, and another without any gap at all. I had some doubts about whether the material would become too fragile if there was a gap, so I decided to create two versions of each. Another issue arose with the hinges, as the guidelines showed that there is no cavity in the frame for them. Unfortunately, I wasn't able to test whether the hinges would work properly if they were built inside the frame, so I created two more versions - one with a cavity in the frame and another without it. This resulted in some cavities appearing on the temple side because my vision was that the gap between the frame and the temple should be kept to an absolute minimum. I hope you'll like these specs. Update: The Temples ver A and Temples ver B have been revised as they were not watertight.