i3 Rework Print Fan 40mm

thingiverse

A print fan mount designed specifically for users of Rework 1.0 extruder systems. The mount is securely attached to the body extruder by utilizing the same M3 screws used to fasten the J-head/E3D hotend, a configuration familiar in Thingiverse designs. **Print Settings:** * **Rafts:** No raft was employed. * **Supports:** They were not needed in my print, but supports can be created for the base angle and possibly the screw holes in the sides, even though they weren't necessary for my particular setup. * **Resolution:** I utilized a 0.2mm resolution for this fan mount. * **Infill Percentage:** The infill was set at 40% to ensure structural integrity. **Print Notes:** The fan mount was successfully printed using ABS and F/F coconut filament, with the latter yielding an extremely appealing appearance. While the coconut/wood filament resulted in a very attractive finish, I found ABS to be lighter, making it my preferred choice.