i3-R Extended Ramps Enclosure

thingiverse

UPDATE 2.18.2020: I've discovered a problem with the MOSFET mount because the holes don't align properly. When I initially designed this, I relied on some online dimensions rather than actual measurements of my specific MOSFET. I will modify the design and reupload it here soon. I will leave up the originals if people would like to view them. UPDATE 1.30.2020: I've updated the model with wire management extended higher up to align better with the wire hole for the extruder and another model with an additional wire manager to manage wires for the steppers. If you end up printing before I do, offer some feedback and let me know if there are better ways to manage the wiring, and I'll try to make changes accordingly. Great case design by RoMaker that worked perfectly for my needs until I upgraded my board to a RAMPS 1.6+ with TMC2130 drivers and noticed I was getting thermal runaway from my heat bed because it is drawing too much power. So I bought a MOSFET but needed a way to mount it. I extended the case and added a MOSFET mount specifically for this MOSFET from Amazon. I've also added spots for some wire management to manage wires somewhat. I haven't printed this yet as I just finished up the remix, but I will update with pictures of the printed part when they are completed. Spacing for the MOSFET and RAMPS should be good because I used a RAMPS model to check my spacing.