i3 CTC Titan Aero X Carriage Rear Plate

thingiverse

This is a modified version of the X carriage Rear Plate from https://www.thingiverse.com/thing:2744724 Included Front Plate so all stls required are in one place, don't forget to like OmNomNomagon's design this is remixed from. The X Carriage endstop part for the original is located on the bottom left, but my printer has it on the top left. Clearly, the endstop would never be triggered when homed. This is my first attempt at modifying a file, and I'm really bad at design. I've left the bottom left endstop bit in all versions in case others want to edit these files. V1: The original with an added endstop bar for switches placed on the top left of the X carriage. V2: Like V1 but with a wider endstop bar so you don't have to flip the trigger switch. I've also added slits to loop the timing belt around and clamp it instead of cutting it short like in V1. Plus, I increased the gap for the timing belt by about 1mm to make it easier to insert. V3: Just like V2 but with a top left endstop that's 10mm longer for those using thicker stepper motors. Even though the bearing fits perfectly in the housing, you should still use screws and nuts to clamp them down. I didn't do this at first and got huge missed steps halfway through prints, throwing my over an inch off course! Also, don't make the same mistake I did: leave the fan shroud for part cooling until last. It needs to be added first to the rear plate; otherwise, it's a nightmare trying to get it on. OmNomNomagon's new fan shroud is still too large, probably due to my Titan being a clone. So, I've remixed it to be a few mm shorter for more room for those who need extra space.