i_Rics Direct Drive - MOD

thingiverse

This is a Direct Drive Mod for the i_Rics Printer. There are two ways to use this mod. Version 1) You use the original carriage from the BOM and simply place the DD bearing on top of it. Version 2 ) You replace the original carriage with my own. This one has the following changes: - The GT2 belts run almost parallel - The GT2 belt is tensioned at the top with a plate (has only aesthetic reasons) - Heat is dissipated slightly differently - At the bottom, the carriage has long holes to adjust spacing. I recommend using spacers during assembly. This increases stiffness. The rear cover must be mirrored once!