Hyundai Amica Car Phone Holder (for Huawei Mate 20 Pro)

thingiverse

This is my initial design I'm uploading to Thingiverse because I couldn't locate another phone car holder that fits both my phone and car vents properly.\r\n\r\nI printed the two components without support, using 20% infill. The prints were made with a Dremel 3D20 on high settings.\r\n\r\n** After printing, you'll need to remove the 1mm pieces at the bottom of the fan holder; these were only added as temporary supports during printing.\r\n\r\n** Please note that I overlooked adding a hole for the charging cable, so I'll remake this design with improvements I've identified. For now, I've drilled a hole to accommodate the cable.