Hyperlite FlosStyle SMA Mount

thingiverse

This is a test update without the receiver tube holders. I tested my version over the weekend and it placed the receiver antennas in the same plane as the vtx antenna, so it wasn't an ideal setup. This is still a nice SMA holder for the frame! SMA mount fits perfectly on the rear of the Hyperlite Flosstyle frame. The SMA holder has a recess to hold the 8mm fixed hex section of the pigtail. When printed, this hex section appears too tight to fit at first, but once you thread the nut on and tighten, the nut pulls the base into the recess (assuming a 100% print rate and 100% extrusion rate). Just don't apply excessive torque - once you've pulled the base into the recess, that's as far as it needs to go. Applying more force will only squish and weaken the TPU. Don't hesitate to share your genuine thoughts about the design.