Hyperlite Floss 3.0 Pyrodrone Fin GoPro Hero mount and GPS & Immortal-T holder
thingiverse
This fin relies on the slots in the Floss 3.0 top plate and two zip ties for mounting. It securely holds a GoPro Hero 5,6,7, a TBS M8 GPS module, and a vertical immortal-T antenna. Please note that if you use the t-antenna holder, position it with the ground plane side facing down and the active plane side up. The active element of the T is connected to the center pin of the UFL via conductivity. Print in TPU with supports on the left side. A 20-50% in-fill ratio works well. The zip-tie that runs front to back forms a full loop around the top plate. Keep in mind that no props are visible, even when using SuperView. GoPro tilt is set at 35 degrees.
With this file you will be able to print Hyperlite Floss 3.0 Pyrodrone Fin GoPro Hero mount and GPS & Immortal-T holder with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Hyperlite Floss 3.0 Pyrodrone Fin GoPro Hero mount and GPS & Immortal-T holder.