Hyperlite Floss 2 Pod

thingiverse

This is a Pod for the Hyperlite floss 2 frame. If you want to use this thing, there are some parts you have to first consider: -Your electronics stack can only be 26mm high. -You need to use a micro size camera. -It's recommended to use a linear antenna. -You have to be okay with removing the nuts under the standoffs in the back. -The cam angle only goes from 47 to 55, but you can melt or cut a bit of the plastic away to make room for another angle. To install this thing you need extra: -2x M2x7mm screw -2x M2 washer Install: First, put the cam in place. Then, use a washer and an M2x7mm screw to secure the camera on one side, then do the same thing on the other side. Then tighten the screws to a point where you can still move the cam up and down but it sits tightly where it is. Installing the pod in the front is simple: Just stick the pod on the 16mm screws and put a self-tightening lock nut on it. In the back, just screw it on the standoffs. Finally, put your antenna through the little slot in the back, now it sits in place, has still space to move away when you hit something and can be easily replaced. That should be it, now you can enjoy your nice-looking new pod.