Hypercube XY joiner raiser

thingiverse

I've noticed a problem since building my Hypercube that the XY carriage was never in the optimum position to give full potential height. This issue has been resolved with a mod that lets me move the XY carriage up 20mm, gaining extra print height for free! Everyone likes getting something without spending money, and if I use my corner raiser along with this modification, I can gain an additional 20mm, netting a total build height of 195mm. That's very exciting! The only thing that needs to be different from the original build materials is a 30mm M3 bolt to hold the bearings for the belt on the left-hand side. Please see the picture. Installation: Replace your original XY joiners with these new ones and trim your top X carriage tube down to around 335mm long, allowing you to go back to the original XY joiners if needed. Once this is done, loosen the XY assembly and move it up to the top.