Hypercube X carriage with i3 rework compatible mount

thingiverse

This is a fantastic remix of the Hypercube carriage by Tech2C.\nThe item is a reworked version of the hypercube carriage proposed by arturslab (capitve nut locks).\nI made several changes:\nI redefined the mounting holes to be compatible with prusa i3 rework, using M4 holes with 23mm horizontal and vertical spacing, allowing for reuse of existing mounting for extruders and hotends.\nThere are only three out of four holes due to limitations in the carriage design. These should be sufficient.\nI also added mounting holes for a homemade direct extruder (M4), as shown on Thingiverse at http://www.thingiverse.com/thing:582520.\nThe M4 15mm spacing allows for mounting of Tech2C's E3D mount.\nBoth belt clamps were reinforced.\nFreecad was used to create this item and further remixes are welcome.\nA warning is issued because the item was created by converting STL into a mesh, then into a solid.\nBoolean operations on such solids may result in missing faces. In that case, recreate the faces from edges and select them with "solid" for exporting a valid STL.\nPrinting this item correctly requires recreating the faces.\nEdit: On March 8, 2017:\nA version was added with nutlock for 4mm screws since it may be challenging to mount the hotend otherwise when the carriage is in place.\nThe print settings used were:\nPrinter: prusa i3 kit\nRafts: No\nSupports: No\nResolution: 0.2\nInfill: 40%\nNotes: PETG\n30 mm/s, 3 perimeters, 0.8 top/bottom, 0.2 layer\n0.5 mm j-head at 245°\nBed temperature 60° with glass and hair spray.\nThe first layer was pressed down firmly.