HyperCube Evolution max z endstop

thingiverse

Adding max Z endstops to the HEVO enables homing to maximum, allowing for seamless recovery from power outages. This feature can be especially useful when paired with a Duet controller board, where the endstops can be connected directly to the extruder's inputs. To implement this setup, you'll need 3mm insets for the sensor holder, the screw for the flag, and the fixation screw on the side. A total of four 3mm insets and four 3mm screws are required for each endstop. The idea is to adjust the flag height using a vertical screw, then secure it in place with a horizontal screw.