Hypercube Evolution Electronics Housing ( HUGE )

thingiverse

This is an alternative take on the electronics compartment of hypercube evolution printers. It uses the back side of the printer to house all the electronics. The Voron Electronics case serves as a base but has been completely redesigned to fit a 300x300x400 HEVO. The Voron Electronics case can be viewed at https://www.thingiverse.com/thing:2155152. This case accommodates the following electronics: - MKS Base Gen1.4 - Maxwell 5V PSU - Raspberry Pi 3 - E3D Pt100 Amp board - 2x AliExpress Mosfets - PSU with 150mm x 50mm screw pattern Bolts and nuts for the housing are as follows: ---------------------------------------------------- 24 M3 brass inserts are needed. 28 M3 Hex Nuts will be required. 32X 10mm M3 Socket Head Cap Screws should be used. 12X 20mm M3 Socket Head Cap Screws are necessary. 10X 25mm M3 Socket Head Cap Screws should be purchased. 8X 10MM M4 Socket Head Cap Screws will be sufficient. Bolts and nuts for the Hardware: ---------------------------------------------------- 4x 8mm M4 Socket Button Head Screws - 24V PSU 4x 8mm M2.5 Socket Head Cap Screws - RPi 16x 8mm M3 Socket Head Cap Screws - MKS, Mosfets, pt100 amp