Hypercube Evolution Alternative Parts

thingiverse

My HEVO is primarily composed of standard parts from Scott_3D, with the exception of those published here. Please refrain from requesting the panels surrounding the electronics bay as they are uniquely tailored to my specific requirements and would not be beneficial to others. **3030_Corner_Bracket_Cover.stl**: A small snap cover for the inner side of 90-degree corner brackets to securely hold or conceal cables. **Cable_Clamp_2020.stl**: Designed for use with 2020 extrusions (bed frame) - single cable tie slot. **Cable_Clamp_3030.stl**: Sized for 3030 extrusions, featuring a single cable tie slot. **Bed_Bracket_slotted.stl**: I created this alternative to the standard bed brackets, which I did not like. To assemble, print two as is and two mirrored in your slicer. Suitable for a 300x300 MK3 bed. **Led_bar.stl**: Used to hold LED strips - bolt extrusions into place then glue the LED strips securely. (**Led_bar_split.stl** is designed for smaller printers). **Cable_Mount_Hotend.stl**: Utilizes the bolt that secures the part cooling fan in place on the carriage, sized for split conduit tubing (https://www.ebay.co.uk/itm/Conduit-Split-Non-Split-Black-Flexible-Cable-Tidy-Tube-Trunking/273140284796) with an internal diameter of 14.5mm. **Cable_Mount_Clamp.stl**: Clamps the conduit at the carriage to the previous part using two cable ties. **Leveling_Wheel_insert.stl**: Requires an M3 nut to be inserted at layer 100 (17mm) during printing. **Leveling_Wheel_slot.stl**: Features a slot for an M3 nut. **Rear_Cable_Tube_Mount.stl, Rear_Cable_Tube_Mount_2.stl and Rear_Cable_Mount_3.stl**: These three parts comprise the cable assembly for the conduit from the carriage. The rear part is designed to fit 25x10mm cable tray. Four 5x3 brass inserts are needed. **Z_Nut_Bracket_1_1.stl**: Suitable for larger anti-backlash nuts sometimes supplied, which only require two securing bolts. **Mid_Cable_Entry.stl**: Fastened to the lower rail to route hotend cables into the 25x10mm cable tray. A cable tie is used to secure the hotend cables. **Extruder_Mount.stl**: Designed for those using a Bowden extruder, this part should fit standard extruder stepper motor mounts supplied with most extruders. **End_Cap.stl**: A small cap for the exposed ends of 3030 extrusions. I recommend placing it before clamping the top rails flush to it and then using my build jig (https://www.thingiverse.com/thing:3388048) to set the 100mm spacing.