Hypercube 300 remixes for 8mm Igus Drylin RJ4JP-01-08 (LM8UU) linear bearings

thingiverse

I wanted to convert my Hypercube 300 to using Igus LM8UU style bearings but If you use the standard clamps to hold them on and you clamp them tight enough so they don't wiggle, then they don't move well at all. Unfortunately all of the remixes I could find were of the original Hypercube parts and I really like Adrian M's redone parts so I remixed them. I recommend printing the clamps with supports on just the very ends where the tabs are that hold the bearings from sliding. With these clamps, you don't have to tighten them down very much at all. You want to use nylock nuts and tighten them just until they don't wiggle and then they slide like butter.